| Quantity: | |
|---|---|
Visbella UV light glue is a fast curing adhesive that can be used in daily repair. It is suitable for bonding metal, glass, ceramics, wood, rubber, PVC, ABS, Acrylic and so on. This product is cured when exposed to UV radiaiton . The speed of cure will depend on the UV intensity as measured at the product surface.The ultraviolet lamp can achieve cure within a short time, safe and convenient operation.
Cautions:
Products should be stored unopened in a cool, dry place out of direct sunlight. Products should be kept at room temperature away from direct light. Protect from extreme heat or cold, do not refrigerate.
This product is light sensitive; exposure to daylight, UV light and artificial lighting should be kept to a minimum during storage and handling. For best performance bond surfaces should be clean and free from grease. Cure rate is dependent on lamp intensity, distance from light source, depth of cure needed or bond line gap and light transmittance of the substrate through which the radiation must pass.
KEEP OUT OF REACH OF CHILDREN.
Surfaces to be bonded should be clean and dry. The plastic coating should be bonded to the site, gently press, plastic full of bonded joints, and then used with UV light irradiation, attention must use the built-in UV lamp, different wavelength UV lamp is not the same, is difficult to guarantee to cure.About 10 seconds will be able to achieve the early curing, if the adhesive area is too large, an appropriate extension of irradiation time. Pay attention to the adhesive parts of at least one side is transparent, UV lamp alignment transparent side irradiation, light can through the surface, the adhesive curing.
Visbella UV light glue is a fast curing adhesive that can be used in daily repair. It is suitable for bonding metal, glass, ceramics, wood, rubber, PVC, ABS, Acrylic and so on. This product is cured when exposed to UV radiaiton . The speed of cure will depend on the UV intensity as measured at the product surface.The ultraviolet lamp can achieve cure within a short time, safe and convenient operation.
Cautions:
Products should be stored unopened in a cool, dry place out of direct sunlight. Products should be kept at room temperature away from direct light. Protect from extreme heat or cold, do not refrigerate.
This product is light sensitive; exposure to daylight, UV light and artificial lighting should be kept to a minimum during storage and handling. For best performance bond surfaces should be clean and free from grease. Cure rate is dependent on lamp intensity, distance from light source, depth of cure needed or bond line gap and light transmittance of the substrate through which the radiation must pass.
KEEP OUT OF REACH OF CHILDREN.
Surfaces to be bonded should be clean and dry. The plastic coating should be bonded to the site, gently press, plastic full of bonded joints, and then used with UV light irradiation, attention must use the built-in UV lamp, different wavelength UV lamp is not the same, is difficult to guarantee to cure.About 10 seconds will be able to achieve the early curing, if the adhesive area is too large, an appropriate extension of irradiation time. Pay attention to the adhesive parts of at least one side is transparent, UV lamp alignment transparent side irradiation, light can through the surface, the adhesive curing.
