| Quantity: | |
|---|---|
Visbella® Copper Spray is a fast drying aerosol product that contains copper to help dissipate heat to prevent gasket burnout and improves heat transfer. Remains tacky to allow gasket re-position. Fills surface imperfections.
For Clean up:
1. Turn can upside - down and spray to clear nozzle.
2. Clean hands with hand cleaners.
Note: Aerosol product will coat 10 to 12 standard gaskets.
Storage:
Products shall be ideally stored in a cool, dry location in unopened containers at a temperature between 8 °C to 28 °C unless otherwise labeled. Optimal storage is at the lower half of this temperature range.
KEEP OUT OF REACH OF CHILDREN.
Directions:
1. Provide adequate ventilation.
2. Surfaces should be free of oil, dirt and grease.
3. Mask areas that should not be coated.
4. Shake can with ball agitator for one minute. For best results, aerosol can should be at room temperature before spray.
5. Holding can 8 to 10 inches from the surface to be coated, press the nozzle and discharge the product uniformly. Apply to both sides of gasket. Avoid over spray. DO NOT SPRAY into engine compartment. Allow solvent to evaporate before assembly.
Visbella® Copper Spray is a fast drying aerosol product that contains copper to help dissipate heat to prevent gasket burnout and improves heat transfer. Remains tacky to allow gasket re-position. Fills surface imperfections.
For Clean up:
1. Turn can upside - down and spray to clear nozzle.
2. Clean hands with hand cleaners.
Note: Aerosol product will coat 10 to 12 standard gaskets.
Storage:
Products shall be ideally stored in a cool, dry location in unopened containers at a temperature between 8 °C to 28 °C unless otherwise labeled. Optimal storage is at the lower half of this temperature range.
KEEP OUT OF REACH OF CHILDREN.
Directions:
1. Provide adequate ventilation.
2. Surfaces should be free of oil, dirt and grease.
3. Mask areas that should not be coated.
4. Shake can with ball agitator for one minute. For best results, aerosol can should be at room temperature before spray.
5. Holding can 8 to 10 inches from the surface to be coated, press the nozzle and discharge the product uniformly. Apply to both sides of gasket. Avoid over spray. DO NOT SPRAY into engine compartment. Allow solvent to evaporate before assembly.
