| Quantity: | |
|---|---|
Visbella® DIY Dent and Ding Repair Kit For Auto usueful to remove small dings and dents from car doors,coffer,roof,..by yourself and without damaging the car paint. It can be used after small collisions or hailing,all over the car body surface, except borders and angles.
Attention: Puller tab must smaller than dent area and similar in shape.
1.Keep the puller tab hold firmly for 10 seconds. Do not push excessively the puller tab against the dent!
2.Place puller bridge stand over the puller tab, setting adjusters to desired length. Screw the knob nut slowly, and continue to rotate until dent is raised. Stop when dent returns to normal surface level of the car body.
3.Loosen thread Knob nut and remove puller bridge stand and puller tab from treated surface.Use the release agent in endowment to remove the dried glue from the surface. Then use the plastic scraper to peel off softened glue patch.
4. If a too high glue spot has been created, use a rubber hammer and lightly tap the Leveling pen against raised spot to remove.
If the dent surface is big, repeat above step.
Safety Information
1. Wear safety goggles and heavy-duty work gloves during use.
2. Contains glue: keep away from children reach. This product is not a toy. Do not allow children to play with or near it .
3. Use as intended in these instructions only.
4. Check before every use, do not use if parts are loose.
5. Keep product labels and nameplates, they report important safety and technical info on the product.
KIT INCLUDES
1x Glue Gun
2x Glue Sticks
1x Plastic Scraper
1x Puller Bridge Stand
2x Wipes
1x Knob Nut
7x Puller tabs
1x Leveling Pen
1x Clean Cloth
Visbella® DIY Dent and Ding Repair Kit For Auto usueful to remove small dings and dents from car doors,coffer,roof,..by yourself and without damaging the car paint. It can be used after small collisions or hailing,all over the car body surface, except borders and angles.
Attention: Puller tab must smaller than dent area and similar in shape.
1.Keep the puller tab hold firmly for 10 seconds. Do not push excessively the puller tab against the dent!
2.Place puller bridge stand over the puller tab, setting adjusters to desired length. Screw the knob nut slowly, and continue to rotate until dent is raised. Stop when dent returns to normal surface level of the car body.
3.Loosen thread Knob nut and remove puller bridge stand and puller tab from treated surface.Use the release agent in endowment to remove the dried glue from the surface. Then use the plastic scraper to peel off softened glue patch.
4. If a too high glue spot has been created, use a rubber hammer and lightly tap the Leveling pen against raised spot to remove.
If the dent surface is big, repeat above step.
Safety Information
1. Wear safety goggles and heavy-duty work gloves during use.
2. Contains glue: keep away from children reach. This product is not a toy. Do not allow children to play with or near it .
3. Use as intended in these instructions only.
4. Check before every use, do not use if parts are loose.
5. Keep product labels and nameplates, they report important safety and technical info on the product.
KIT INCLUDES
1x Glue Gun
2x Glue Sticks
1x Plastic Scraper
1x Puller Bridge Stand
2x Wipes
1x Knob Nut
7x Puller tabs
1x Leveling Pen
1x Clean Cloth
